Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Folsom, CA
Chimney repair in Folsom usually means one of two things: rebuilding a spalling brick crown on a 1920s home near Sutter Street, or replacing a rusted chase cover on a 1990s tract house in Empire Ranch. The housing stock here splits almost exactly down the middle, and the repair that works for one side is wrong for the other. We diagnose both. If you need a chimney sweep or dryer vent cleaning, those services have their own Folsom pages linked below. For structural work, liner issues, caps, crowns, and flashing, call (833) 593-4469 and we’ll tell you what we’re seeing before we quote a number.
Why Folsom Homes Are Different
Folsom’s original downtown grid, ZIP 95630, holds a concentration of Victorian and early-1900s brick homes that have survived more than a century of wet-dry cycles. Many of those chimneys were rebuilt after the 1950s, and sweeps here routinely find unlined mortar joints that predate modern flue liner codes. That condition is rare in the east-side subdivisions like Broadstone, where 1990s and 2000s tract homes run prefabricated metal fireplaces and direct-vent terminations through wood-framed chases. Two completely different systems, twelve minutes apart.
Climate compounds the divide. Folsom’s long, dry summers bake masonry crowns until hairline cracks open up. Then the mild, wet winters push water into those cracks, and the freeze-thaw cycle does the rest. Meanwhile, fall wildfire smoke from the Sierra foothills sits over the city for weeks at a time, which means smoke-odor calls spike right when families want to light the first fire of the season. Scheduling a sweep or repair before October is the difference between a clean flue and a two-week wait.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Main Folsom Services
Most Folsom homeowners call us for one of two reasons: the annual sweep before burning season, or a dryer vent that hasn’t been touched since the home was built. Both are handled by the same specialist team.
Chimney Sweep in Folsom
A proper sweep in Folsom isn’t the same job on Sutter Street as it is in Empire Ranch. Historic brick chimneys need careful inspection of unlined mortar joints and decades of creosote layered onto irregular surfaces. Prefabricated metal flues in newer subdivisions need the right brush type so the thin stainless liner isn’t scored. We inspect as we sweep, and you get a photo report of what we found, not a scare story. For the full breakdown of what a sweep includes here and what it costs, see our Chimney Sweep in Folsom page. Fall appointments fill first, and smoke season doesn’t wait.
Dryer Vent Cleaning in Folsom
Lint buildup is one of the leading causes of residential structure fires in the United States, and Folsom’s larger tract homes often push dryer vents through long runs that snake from a second-floor laundry room to an exterior wall. The longer the run, the more lint collects, and the harder the dryer works. We clear the full run, check the termination hood, and confirm airflow at the exterior vent. It’s the same whole-exhaust-system approach we bring to chimneys. Details and pricing live on our Dryer Vent Cleaning in Folsom page. If you can’t remember the last time it was done, that’s your answer.
Chimney Repair in Folsom
Folsom’s chimney repair work splits along the same line as its housing stock. In the historic downtown grid around Sutter Street, we’re rebuilding brick crowns, repointing mortar joints, and relining flues that were never built with modern liners in the first place. In the 1990s and 2000s subdivisions like Broadstone and Empire Ranch, we’re replacing rusted chase covers, repairing flashing where stucco meets prefab metal chimneys, and installing caps on direct-vent terminations. The common thread is water: Folsom’s wet winters push moisture into whatever crack or gap exists, and the long dry summers bake the damage in. The fix starts with a camera inspection that shows you exactly what’s failing before anyone recommends a repair. Our full Chimney Repair service details are here.
Chimney Cap Installation
Signs you need it
Rain streaking down the flue, bird or squirrel noise in the chimney, or a missing cap entirely on an older brick chimney.
What it costs in Folsom
Chimney cap installation in Folsom typically ranges from $250 to $600 depending on the cap type and chimney crown condition.
How we do it
We measure the flue, secure the cap to the crown or tile with mechanical fasteners and a weatherproof seal, and confirm it drains properly.
Chimney Cap Replacement
Signs you need it
A rusted-through cap on a newer home’s prefab metal chimney, or a cap that’s blown off during a winter storm and left the flue exposed.
What it costs in Folsom
Chimney cap replacement in Folsom typically falls between $300 and $700, with galvanized caps at the lower end and stainless or copper at the upper end.
How we do it
We remove the old cap, inspect the termination for hidden rust or water damage, and install the replacement specified for your chimney’s exact make and diameter.
Chimney Liner Installation
Signs you need it
Cracked or missing flue tiles visible during a sweep, an unlined historic brick chimney in the 95630 ZIP, or a failing prefab liner in a newer home.
What it costs in Folsom
Chimney liner installation in Folsom typically ranges from $2,500 to $6,000 depending on flue size, height, and the liner system specified.
How we do it
We size the liner to the appliance and flue dimensions, run a camera to map the flue first, then install a DuraFlex stainless system or comparable professional-grade liner and insulate per code.
Chimney Flashing Repair
Signs you need it
Water staining on the ceiling near the chimney, damp drywall in an upstairs room, or visible gaps where the roof plane meets the chimney masonry.
What it costs in Folsom
Chimney flashing repair in Folsom usually runs from $350 to $900, depending on whether we’re replacing a section or the full step and counter flashing.
How we do it
We cut out the failed flashing, install new step flashing and counter flashing with proper overlaps, and seal the transitions against Folsom’s winter rain.
Chimney Crown Repair
Signs you need it
Spalling brick on the top courses, a crown that’s cracked into pieces, or water pooling on the crown after rain instead of draining off.
What it costs in Folsom
Chimney crown repair in Folsom typically costs between $400 and $1,200 depending on whether we patch and seal or pour a new reinforced crown.
How we do it
We remove the failed surface, form and pour a properly sloped crown with an overhang and drip edge, and use a flexible sealant that moves with Folsom’s thermal swings.
What Chimney Repair Costs in Folsom
| Item | Typical range in Folsom |
|---|---|
| Chimney cap installation | $250 – $600 |
| Chimney cap replacement | $300 – $700 |
| Chimney liner installation | $2,500 – $6,000 |
| Chimney flashing repair | $350 – $900 |
| Chimney crown repair | $400 – $1,200 |
Does a cracked chimney crown really need repair in Folsom?
Yes. Folsom’s wet winters force water into hairline crown cracks, and the following dry summer expands the damage. What starts as a $500 crown repair becomes a $3,000 masonry rebuild if water reaches the brick courses below. Call (833) 593-4469 and we’ll camera the crown before recommending anything.
Do I need a new liner, or can the existing one be saved?
Not every cracked liner means a full reline. We run a camera through the flue first, then tell you plainly whether a HeatShield resurfacing treatment will restore the existing tiles or whether a full liner install is required. You’ll see the footage, not just hear our interpretation.
Brands We Service in Folsom
We install and service chimneys and venting built around professional-grade components from Olympia Chimney, Famco, and Copperfield, including stainless liner systems from DuraFlex. Parts are ordered to spec for your chimney, which keeps turnaround short on standard repairs. See the full our brands list for what we specify and why.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Folsom, CA
| Service | Typical range in Folsom |
|---|---|
| Chimney sweep (masonry fireplace) | $180 – $320 |
| Chimney sweep (prefabricated fireplace) | $180 – $300 |
| Dryer vent cleaning | $120 – $230 |
| Chimney cap installation | $250 – $600 |
| Chimney cap replacement | $300 – $700 |
| Chimney liner installation | $2,500 – $6,000 |
| Chimney flashing repair | $350 – $900 |
| Chimney crown repair | $400 – $1,200 |
What pushes the price up in Folsom is usually chimney height and access. A three-story home on a hillside lot in El Dorado Hills-adjacent Folsom needs more ladder work and safety setup than a single-story rancher near the American River. The bid we give you before booking is the price you pay, unless the camera inspection reveals something that genuinely changes the scope, and you’ll see exactly what we saw before you approve anything.
Neighborhoods We Serve in Folsom
We work throughout Folsom on a regular schedule, not a fly-by-night rotation.
- Historic downtown grid near Sutter Street (95630)
- Empire Ranch (95630 / 95671)
- Broadstone (95671)
- Briggs Ranch and the east-side subdivisions (95671)
- Folsom Ranch south of Highway 50 (95763)
Most chimney repair estimates in Folsom are scheduled within a week, and we try to cluster east-side and downtown jobs so we’re not burning fuel crisscrossing the city.
Service Area – Cities Near Folsom
Beyond Folsom, our service area reaches Granite Bay, CA, El Dorado Hills, CA, Gold River, CA, and Citrus Heights, CA. Each area has its own housing quirks, from sprawling Granite Bay custom homes to tight Citrus Heights ranches, but the diagnostic approach stays the same: camera first, then a straight answer.
Serving Folsom, CA – Our Local Coverage Area
We’re based in the Folsom area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Folsom
Most Folsom sweeps and inspections are scheduled within five to seven days. During September and October, when smoke season pushes everyone to test their fireplaces, that window stretches, which is why we tell homeowners to book their pre-season sweep in August if they can. Repair estimates follow a similar cadence, with emergency water-intrusion calls prioritized.
Most cap, crown, flashing, and liner work falls under routine maintenance and does not require a city permit. Major structural rebuilds or full chimney removals may trigger Folsom’s building permit requirements. We’ll tell you during the estimate if your job crosses that line, and we’ll spell out exactly what the city requires before work begins.
Yes. The homes in the 95763 ZIP, including the Folsom Ranch area, are mostly newer construction with prefabricated fireplaces and direct-vent gas systems. We sweep those flues with the correct brush specifications, inspect the chase covers and terminations, and handle dryer vent runs in the same visit when needed.
If your Folsom chimney has a problem you can see, smell, or hear, call (833) 593-4469 for a straight diagnosis and a free estimate. We’ll tell you what needs fixing now, what can wait, and what the camera actually shows.
What happens when you call
- 1A real person answersNo phone trees. Talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you. The visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Folsom Customers Say
"Thorough sweep and a clear report. He was running late from the job before and arrived near the end of the window, though he did call to warn me."
- Shane Schaefer"No issues with the actual work. I did have to call twice to get the invoice emailed to me, which was mildly annoying. The repair itself has been fine."
- Beatriz Herrera"Level two inspection before we bought the house. The report was detailed enough to use as a negotiating point and he explained every photo in it."
- Shannon Quinn